livebox:hah_hahnode:nanode_gateway

This is an old revision of the document!


Nanode Gateway

dropshadownanode1.jpg

What this does is it accepts an RF packet and dump the same format xAP message onto the Ethernet as the xap_serial program would do.

This one embedded device can replace the base jeenode + xap-serial running on the livebox as a standalone solution.

Here is a 20,000 ft view of how it fits into the network.

This device acts as a pseudo xap-serial service and will transmit a packet conforming to the xAP Serial Schema, however as its not been programmed to be a true xap-serial device it will only generate Serial.Received class messages.

Once the firmware is flashed the only details that requires configuration are the NODE ID, Group and RF Frequency these must be done via the serial interface use to flash the device. The firmware will obtain an IP address via DHCP.

Once operational it will transmit onto the Ethernet a xAP heartbeat every minute to let you know its alive.

xap-hbeat
{
v=12
hop=1
uid=FFABCD00
class=xap-hbeat.alive
source=dbzoo.nanode.gateway
interval=60
port=0
}
  • livebox/hah_hahnode/nanode_gateway.1370149677.txt.gz
  • Last modified: 2013/06/02 05:07
  • by brett