livebox:universalrfrx

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
livebox:universalrfrx [2013/09/05 06:05] – [The receiver] brettlivebox:universalrfrx [2017/09/15 12:37] (current) brett
Line 5: Line 5:
 {{:livebox:urfrx-block-diagram.png}} {{:livebox:urfrx-block-diagram.png}}
  
-With the virtual serial port mode this makes it possible to combine the HAHCentral sketch with the RFRX receiver code module.  One piece of hardware can be used to communicate with the [[hah_hahnode|HAHNodes]] and with the 433Mhz RF receiver hardware.+With the virtual serial port mode this makes it possible to combine the HAHCentral sketch with the RFRX receiver code module.  One piece of hardware can be used to communicate with the [[hah_hahnode|HAHNodes]] and with the 433MHz RF receiver hardware.
  
 It would also allow you to combine say the RFGateway sketch using the Nanode hardware with the RF hardware and have the xap-serial message being dumped directly onto the Ethernet.  Many options available with these architecture choices. It would also allow you to combine say the RFGateway sketch using the Nanode hardware with the RF hardware and have the xap-serial message being dumped directly onto the Ethernet.  Many options available with these architecture choices.
Line 12: Line 12:
 The hardware to slurp and detect what looks like a valid RF signal from all the background noise.  With this hardware we don't pre-code what RF signals we are going to look for, which is what most purpose built RF receivers do. The hardware to slurp and detect what looks like a valid RF signal from all the background noise.  With this hardware we don't pre-code what RF signals we are going to look for, which is what most purpose built RF receivers do.
  
-The source: http://livebox-hah.googlecode.com/svn/trunk/userapps/arduinoYou will also need the RFRX Library .+The source: https://github.com/dbzoo/hah/tree/master/userapps/arduino You will also need the RFRX Library .
  
 <note>The RFRX library is part of the HAHCentral sketch so by attaching a RF receiver to this existing hardware you can get this functionality for very little extra cost.  Just the cost of a RF Rx unit, which is about 3-4 quid.</note> <note>The RFRX library is part of the HAHCentral sketch so by attaching a RF receiver to this existing hardware you can get this functionality for very little extra cost.  Just the cost of a RF Rx unit, which is about 3-4 quid.</note>
  • livebox/universalrfrx.txt
  • Last modified: 2017/09/15 12:37
  • by brett