livebox:hah_microcontroller

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
livebox:hah_microcontroller [2012/04/16 23:05] – [Command Interface] brettlivebox:hah_microcontroller [2012/06/05 15:53] (current) – [Microcontroller firmware] brett
Line 9: Line 9:
  
  **The current release is v3.4**  **The current release is v3.4**
 +
 +On the top RHS of every HAH web UI page, you will see 'Build: vvv.v/x.x'
 +
 +vvv.v is the HAH firmware build. x.x is the AVR code version.
 +
 +You can force the xap-livebox program to communicate at a specific version if auto detection of the AVR firmware version is failing using the following setting in your /etc/xap-livebox.ini file.
 +
 +<code>
 +[hardware]
 +major=3
 +minor=4
 +</code>
 +
 ===== Command Interface ===== ===== Command Interface =====
  
Line 104: Line 117:
 ==== on / off ==== ==== on / off ====
  
-Toggle a relay or RF relay from the on to the off state.+Toggle a relay on/off.
 <code> <code>
 >on 1 >on 1
Line 110: Line 123:
 </code> </code>
  
 +For the M8 firmware this was also overloaded to control RF devices.  This was replaced in the 328 firmware with [[universalrf]]
 +<code>
 +> on 5
 +</code>
  
 +The 1st RF sequence saved into EEPROM would be addressable as 5, the 2nd as 6 etc..
 ==== lcd ==== ==== lcd ====
  
  • livebox/hah_microcontroller.txt
  • Last modified: 2012/06/05 15:53
  • by brett