Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revisionLast revisionBoth sides next revision | ||
atmel:n76e003 [2019/09/28 22:34] – minerva9 | atmel:n76e003 [2019/10/07 14:07] – minerva9 | ||
---|---|---|---|
Line 9: | Line 9: | ||
Had kinda hoped that somebody out there might have written up a guide on how to use this board with the BASCOM-8051 BASIC compiler but a decent ' | Had kinda hoped that somebody out there might have written up a guide on how to use this board with the BASCOM-8051 BASIC compiler but a decent ' | ||
- | So, a few notes on how this might work. As things stand (Sept 2019), some parts are ordered and a bit of research is started. As and when the parts arrive and can be played with, notes will be added here. N.B. To date, I've not even been able to program the device! | + | So, a few notes on how this might work. As things stand (Oct 2019), some parts are ordered and a bit of research is started. As and when the parts arrive and can be played with, notes will be added here. N.B. To date, I've not even been able to program the device! |
The chip is a 20 pin surface mount part. Manufacturer datasheet (a 273 page .pdf) can be found [[https:// | The chip is a 20 pin surface mount part. Manufacturer datasheet (a 273 page .pdf) can be found [[https:// | ||
+ | Asserted that my dev board hasn't been setup with a serial bootloader, so I'll have to await the arrival of the ' | ||
\\ | \\ | ||
Line 20: | Line 21: | ||
\\ | \\ | ||
\\ | \\ | ||
- | Note: Whilst the above picture is a good overview, it doesn' | + | Note: Whilst the above picture is a good overview, it doesn' |
\\ | \\ | ||
\\ | \\ | ||
Line 102: | Line 103: | ||
This chip has both user program and bootloader areas. It should be possible to use the Nuvoton supplied serial bootloader to allow the board to be programmed via a standard USB to serial port adaptor. | This chip has both user program and bootloader areas. It should be possible to use the Nuvoton supplied serial bootloader to allow the board to be programmed via a standard USB to serial port adaptor. | ||
\\ | \\ | ||
- | ToDo: Need to find out if the board comes pre-supplied with a bootloader. | + | ToDo: |
+ | \\ | ||
+ | \\ | ||
+ | * Need to find out if the board comes pre-supplied with a bootloader. | ||
+ | * A small enclosure will need to be milled to hold this part. | ||
=== Some links === | === Some links === |